| Hardware Specification |
| Interface |
LAN / WAN : 1 x 10/100Mbps Auto MDI/MDI-X RJ45 port |
| Antenna |
Gain: 1 x Internal 2dBi Antenna Orientation: Omni-directional |
| Button / Switch |
Front panel (from left to right): - Mode Selection Switch (Router / Client / AP) - WPS Button - Power On / Off Switch
Rear panel: - Reset button * Push for above 5 seconds to reset to factory default settings |
| LED Indicators |
PWR, WLAN, WAN/LAN, WPS, CHG |
| Material |
Plastic |
| Dimension (W x D x H) |
88 x 62 x 18 mm |
| Weight |
With battery: 80g Without battery: 58g |
| Battery |
Built-in Rechargeable Li-ion Battery (3.7V, 1050mAh) |
| Power Requirement |
DC 5V , 0.4A maximum, connected through mini-USB connector |
| Power Adapter |
AC Input: 100~240V AC (50/60Hz) DC Output: 5V with max. 1A current |
| Standard Accessory |
Power Adapter x 1, USB Cable x 1, Ethernet Cable x 1, Li-ion Battery x 1, CD-ROM x 1, Quick Guide x 1 |
| Wireless Interface Specification |
| Standard |
Compliance with IEEE 802.11b/g/n |
| Frequency Band |
2.4 ~ 2.4835GHz |
| Extend Frequency |
DSSS |
| Modulation Type |
DBPSK, DQPSK, QPSK, CCK and OFDM (BPSK / QPSK / 16-QAM / 64-QAM) |
| Data Transmission Rates |
11n: Up to 150Mbps (Dynamic) 11g: Up to 54Mbps (Dynamic) 11b: Up to 11Mbps (Dynamic) |
| Transmission Distance |
Indoor up to 100m Outdoor up to 300m (Depends on the environment conditions) |
| Channel |
America/ FCC: 2.412 ~ 2.462GHz (11 Channels) Europe/ ETSI: 2.412 ~ 2.472GHz (13 Channels) Japan/ TELEC: 2.412 ~ 2.484GHz (14 Channels) |
| Max. RF Power |
20 dBm (EIRP) |
| Receive Sensitivity |
135M: -68dBm@10% PER 54M: -68dBm@10% PER 11M: -85dBm@8% PER |
| Software Features |
| Operation Mode |
■ AP ■ Router ■ Client (Switchable by hardware) |
| Wireless Mode |
AP, WDS, Repeater (WDS+AP), Universal Repeater (AP + Client) |
| Encryption Security |
WEP (64/128-bit) encryption security WPA-Enterprise / WPA2-Enterprise (TKIP/AES) WPA-Personal / WPA2-Personal (TKIP/AES) 802.1x Authentication |
| Wireless Security |
Provides wireless LAN ACL (Access Control List) filtering Wireless MAC address filtering Supports WPS (Wi-Fi Protected Setup) Multiple SSID up to 5 wireless groups, each mapped to a separate 802.1p/q tagged VLAN Enable / Disable SSID Broadcast |
| Wireless Advanced |
WMM (Wi-Fi Multimedia): 802.11e Wireless QoS IAPP (Inter Access Point Protocol): 802.11f Wireless Roaming Provides Wireless Statistics |
| Internet Connection Type |
Shares data and Internet access by supporting the following types of internet access: - PPPoE - Dynamic IP - Static IP - PPTP - L2TP |
| Firewall |
NAT firewall with SPI (Stateful Packet Inspection) Built-in NAT server supporting Port Forwarding, and DMZ Built-in firewall with IP address/ MAC address/ Port/ URL filtering Supports ICMP-FLOOD, UDP-FLOOD, TCP-SYN-FLOOD filter, and DoS protection Supports 802.1Q VLAN up to 4 |
| Routing Protocol |
Static / Dynamic (RIP1 and 2) Routing |
| VPN Pass-through |
PPTP, L2TP, IPSec, IPv6 |
| LAN |
Built-in DHCP server supporting static IP address distributing Supports UPnP, Dynamic DNS Supports IGMP Proxy Supports 802.1d STP (Spanning Tree) IP / MAC-based Bandwidth Control |
| System Management |
Web-Based (HTTP) management interface SNTP time synchronize Easy firmware upgrade System Log supports Remote Log |
| Standards Conformance |
| IEEE Standards |
IEEE 802.11n (1T1R, up to 150Mbps) IEEE 802.11g IEEE 802.11b IEEE 802.11i IEEE 802.3 10Base-T IEEE 802.3u 100Base-TX IEEE 802.3x Flow Control |
| Other Protocols and Standards |
CSMA/CA, CSMA/CD, TCP/IP, DHCP, ICMP, NAT, PPPoE, SNTP |
| Environment |
| Temperature |
Operating: 0 ~ 40 Degree C Storage: -40 ~ 70 Degree C |
| Humidity |
Operating: 10 ~ 90% (Non-Condensing) Storage: 5 ~ 90% (Non-Condensing) |